• WARNING-Read all instructions before using.
  The Sunburst^® is different than any other radio or flashlight you have ever owned.
  General
• Before 1st use or After long term storage ~ Charge the Sunburst^® for 12 hours
  with AC/DC Adapter by following the AC/DC or Car Charging Instructions (See Below).
• Using the Power Selection Switch [figure 1 #5] the Sunburst^® will only operate from internal cells in position 2•DYNAMO [figure 2 B]. The position 1•POWER OFF [figure 2 A] is for power off & Position 3•BATT [figure 2 C] is for your own batteries only (This is only for a backup) See POWER & CHARGING INSTRUCTIONS (See Below)
• When finished using Sunburst^® always remember to turn off flashlight, radio, etc. & then Slide Power Selection Switch [figure 1 #5] to position 1•POWER OFF [figure 2 A]

Figure #1
Functional Layout

• 1-Flashlight/Lantern Lens
• 2-Tuning Knob
• 3-On/Off Volume Knob
• 4-AM/FM/Weather Band Switch
• 5-Power Selection Switch
• 6-Dynamo Crank
• 7-Flashlight/LanternOff/
      /Flasher/Siren Switch
• 8-Solar Panel
• 10-Earphone Jack
• 11-AC/DC In & Out Jack
• 12-Battery Housing Cover
• 13-Weather Tight Speaker Grill

• AM/FM Radio & Weather Band
• Slide Power Selection Switch [figure 1 #5] to position 2•DYNAMO [figure 2 B].
• Select AM , FM, or Siren by pushing the Band Switch [figure 1 #4].
• Rotate the On/Off Volume Knob [figure 1 #3] to ON (clock wise until you hear a click). And then, to the desired volume level. To conserve power when not in use make sure the Sunburst^® is off (turn counter clock wise until you hear a click).
• Rotate the Tuning Knob [figure 1 #2] to the desired station and adjust for best station reception.
• To fine tune, turn dial slowly.
• For personal listening option, use Earphone Jack [figure 1 #10], with optional earphone or headphone available on attached order form. Notice the speaker is automatically disconnected when the ear/headphone is plugged into Earphone Jack [figure 1 #10].
  
  
  Siren
• Slide Power Selection Switch [figure 1 #5] to position 2•DYNAMO [figure 2 B].
• Slide Flashlight/Off/Flasher Switch [figure 1 #7] to BLINK/SIREN and turn on the On/Off Volume Knob [figure 1 #3] to ON (clock wise until you hear a click).
• To vary pitch adjust On/Off Volume Knob [figure 1 #3].
  
  
  Flashlight
• Slide Power Selection Switch [figure 1 #5] to position 2•DYNAMO [figure 2 B].
• Slide Flashlight/Off/Flasher Switch [figure 1 #7] to ON for solid beam or BLINK/SIREN for strobe flashing light.

• CARE AND MAINTENANCE
• Never use solvents containing benzol or petroleum for cleaning the Sunburst^®. Wipe off dust and stains with a soft damp cloth.
• Take out the back up batteries if the Sunburst^® is not used for a long time.
• Exposure to temperature over170^oF (80^oC) may damage the plastic case. {Never put Sunburst® in car window, As explained in By Solar (See Above).
• To change bulb in flashlight, unscrew open Flashlight Lens [figure 1 #1]. Replace bulb then replace lens. Spare Bulb stores under the Battery Housing Cover [figure 1 #12].
  
  
  Sleep Mode
• If sound, flashlight becomes weak or dim, this is an indication that the built-in batteries are discharged and must be recharged before further use. Further use could cause the Sunburst^® to go into a sleep mode.
• To bring Sunburst^® out of a sleep mode it will take 3-4 times longer to recharge & must be charged with AC or Car Adapter {or sometimes Dynamo will also work}. Use only approved SunStar’s Sunburst^® AC/DC or Car adapters (for ordering optional AC/DC or Car adapters contact SunStar^® or see your local dealer).