• WARNING-Read all instructions before using.
  The SunTapCombo^® is different than any other radio or flashlight you have ever owned.
  General
• Before 1st use or After long term storage ~ Charge the SunTapCombo^® for 12 hours
  with AC/DC Adapter by following the AC/DC or Car Charging Instructions (See Below).
• Using the Power Selection Switch [figure 1 #5] the SunTapCombo^® will only operate from internal cells in the 1•POWER ON [figure 2 A] position. The 3•POWER OFF [figure 2 C] position is for power off & 2•BATT [figure 2 B] position is for your own batteries only (This is only for a backup) See POWER & CHARGING INSTRUCTIONS (See Below)
• When finished using SunTapCombo^® always remember to turn off flashlight, radio, etc. & then Slide Power Selection Switch [figure 1 #5] to position 3•POWER OFF [figure 2 C]

Figure #1
Functional Layout

• 1-Flashlight/Lantern Lens
• 2-Tuning Knob
• 3-On/Off Volume Knob
• 4-AM/FM/Weather Band Switch
• 5-Power Selection Switch
• 6-Dynamo Crank
• 7-Flashlight/LanternOff/
      /Flasher/Siren Switch
• 8-Solar Panel
• 9-Red & Green LED Lights
• 10-Earphone Jack
• 11-AC/DC In & Out Jack
• 12-Battery Housing Cover
• 13-Weather Tight Speaker Grill
• 14-360^o Swivel Antenna

• AM/FM Radio & Weather Band
• Slide Power Selection Switch [figure 1 #5] to position 1•POWER ON [figure 2 A].
• Select AM , FM, or Weather band broadcasting by pushing the Band Switch [figure 1 #4].
• Rotate the On/Off Volume Knob [figure 1 #3] to ON (clock wise until you hear a click). And then, to the desired volume level. To conserve power when not in use make sure the SunTapCombo^® is off (turn counter clock wise until you hear a click).
• Rotate the Tuning Knob [figure 1 #2] to the desired station and adjust for best station reception.
• Rotate swivel antenna [figure 1 #14] for best reception .
• To fine tune, turn dial slowly.
• For personal listening option, use Earphone Jack [figure 1 #10], with optional earphone or headphone available on attached order form. Notice the speaker is automatically disconnected when the ear/headphone is plugged into Earphone Jack [figure 1 #10].
• The weather band is ran by the federal government under the direction of the FCC. Turn the dial slowly with the antenna up to see if you can find the station for your area, or check with your local authorities and may not be available in all areas.
  
  
  Siren
• Slide Power Selection Switch [figure 1 #5] to position 1•POWER ON [figure 2 A].
• Slide Flashlight/Off/Flasher Switch [figure 1 #7] to BLINK/SIREN and turn on the On/Off Volume Knob [figure 1 #3] to ON (clock wise until you hear a click).
• To vary pitch adjust On/Off Volume Knob [figure 1 #3].
  
  
  Flashlight
• Slide Power Selection Switch [figure 1 #5] to position 1•POWER ON [figure 2 A].
• Slide Flashlight/Off/Flasher Switch [figure 1 #7] to ON for solid beam or BLINK/SIREN for strobe flashing light.
• Slide out Flashlight/Lantern Lens [figure1 #1] & stand vertically to be an area lantern.

• CARE AND MAINTENANCE
• Never use solvents containing benzol or petroleum for cleaning the SunTapCombo^®. Wipe off dust and stains with a soft damp cloth.
• Take out the back up batteries if the SunTapCombo^® is not used for a long time.
• Exposure to temperature over170^oF (80^oC) may damage the plastic case. {Never put SunTapCombo® in car window, As explained in By Solar (See Above).
• To change bulb in flashlight, unscrew open Flashlight Lens [figure 1 #1]. Replace bulb then replace lens. Spare Bulb stores under inner housing cover inside the Flashlight Lens [figure 1 #1] (Open inner housing cover by pushing in tab).
• To change rechargeable cells, unscrew open Flashlight Lens [figure 1 #1] & open inner housing cover, by pushing in tab. Replace cell pack by unplugging then replace inner cover & lens. Use only approved SunStar’s Cell Pack (for ordering optional cell pack, contact SunStar^® or see your local dealer).
  
  
  Sleep Mode
• If sound, flashlight or the Red LED Lights{Low Power Indicator} [figure 1 #9] becomes weak or dim, this is an indication that the built-in batteries are discharged and must be recharged before further use. Further use could cause the SunTapCombo^® to go into a sleep mode.
• To bring SunTapCombo^® out of a sleep mode it will take 3-4 times longer to recharge & must be charged with AC or Car Adapter {or sometimes Dynamo will also work}. Use only approved SunStar’s SunTapCombo^® AC/DC or Car adapters (for ordering optional AC/DC or Car adapters contact SunStar^® or see your local dealer).